X-Racer Quadrant 2-6S 35A 32Bit BLHeli_32 ESC Dshot1200

The new X-Racer Quadrant BLHeli_32 ESC has followed the design of previous 4-in-1 design of X-Racer Quadrant. It is not a single board, but four tiny ESCs can be installed separately on the arms, or installed together like a PCB under the flight controller. This is the 35A version, there is also another 25A version available for your choice.

• Uses the latest BLHeli_32 firmware.
• Dshot up to at least Dshot1200.
• At rates up to at least 32kHz is supported.
• Four tiny ESCs can be installed separately on the arms, or installed together like a PCB under the flight controller.
• 2-6s Lipo input.
• Rated at 35A current with a max of 50 amps of current load (Less than 10s).
• Small in size: 20 x 24mm
• 3 grams each piece and about 12 grams for a set of 4 pieces.
• Compatible to BetaflightF3 Flight Controller

Specifications:

• programmable pwm frequency, up to 48kHz, that can run motors even smoother, and also allows for moving of small but potentially disturbing humps in the throttle response. All ESCs have these bumps, with BLHeli_32 they can now be moved in the rpm range, to a place where the system has low sensitivity to them.
• Like auto timing. Which is not the option to choose if you’re after max power. But if you want the most efficient running with very good robustness against desync, it is the perfect choice.
• voltage and current limiting. Which is implemented in the code, and will be supported on some ESCs. Voltage limiting is desirable for fixed wing crafts. And current limiting adds protection against ESC failure.
• programmable brake on stop force. Which allows control of the braking of fixed wing props.
• improved direction change in bidirectional mode.
• more to come in the future. Such as setup from the FC by using Dshot commands. Such as telemetry functionality. There is room to grow performance and functionality.